Shed & Hot Tub Removal in Anderson, IN
Shed removal and hot tub removal are demolition jobs on a small scale. A rotting wood shed, a rusted metal one or a hot tub that has not run in years has to be emptied, disconnected, taken apart and carried out of a backyard, often through a gate. Each produces a load of mixed material, wood, metal, shingles, plastic and sometimes concrete, that has to be sorted and hauled. HomeGuide's 2026 figures put shed removal at $250 to $2,000 and a typical hot tub removal at $200 to $600. Smaller yard debris is covered on the yard waste and brush page.
Shed removal $250 - $2,000 ($1,200 - $3,500 with a concrete pad); hot tub typically $200 - $600 · full pricing guide
Shed removal starts inside the shed. Everything stored there has to come out first, and sheds tend to hold gas cans, old paint, pesticides and fertilizer, which belong at a household hazardous waste drop-off such as the Madison County Recycling Center, not in a hauler's truck. Any electrical service to the shed should be disconnected by an electrician. The structure is then taken apart from the roof down, and the pieces are sorted: metal panels and framing to scrap, clean lumber and shingles to disposal, and anything reusable set aside.
Size and the foundation drive the price. HomeGuide's 2026 shed removal figures run $250 to $2,000 overall, with an 8 by 12 foot shed at $400 to $1,800, a 10 by 12 at $600 to $2,200 and a 12 by 20 at $1,000 to $3,200. Removing a concrete pad along with the shed raises the range to $1,200 to $3,500. The same source says the work takes anywhere from about four hours to two days, depending on size, construction and access.
A hot tub is heavier and more awkward than it looks, especially once water has soaked into its insulation. HomeGuide puts the average removal at about $400, typically $200 to $600, with a minimum near $120 and a maximum near $800, and adds $100 to $130 when the tub has to be carried up or down stairs. The tub has to be drained and its dedicated electrical circuit disconnected before the crew arrives or as the first step. Many are cut into sections on site so they fit through a gate and into a truck.
Decks, play sets, fences and above-ground pools come apart the same way, with the same sorting of wood, metal and hardware. Pressure-treated lumber from an old deck is not a firewood candidate, since burning it releases the chemicals used to treat it. Older outbuildings sometimes used cement-board siding or roofing that may contain asbestos, and material like that is worth testing before anyone breaks it up. Clearing a backyard of several structures at once usually costs less than removing them one at a time.
Free quote
When a Backyard Structure Needs to Go
Anderson owners usually call about shed and hot tub removal for reasons like these:
- A wood shed with a rotting floor, sagging roof or leaks
- A rusted metal shed with holes and loose panels
- A hot tub that has not run in years
- A deck or play set that has become unsafe
- A backyard being cleared before a sale or a new project
- An above-ground pool no one uses anymore
Remodel debris coming out at the same time? See construction debris removal.
What happens on teardown day
A shed teardown follows the reverse of how it was built. The crew clears the contents and confirms the power is off, then removes the roofing, the roof framing, the walls and finally the floor. Nails and screws are gathered as the work goes so none are left in the lawn.
Metal goes to one pile, wood to another, shingles to a third. If the shed sat on a gravel base, the stone can often stay as a bed for the next use of the space. A concrete pad is broken with a jackhammer or a demolition saw and loaded last, since it is the heaviest part of the load.
Access through gates and tight yards
A backyard behind a fence with a single gate is common, and that gate often decides how a job is done. A hot tub is usually wider than a standard gate, so it is cut into sections unless a fence panel can come out. A shed comes apart into pieces small enough to carry, but a long wall section may need to go over a fence rather than through it.
Crews also plan around trees, garden beds and septic or utility lines. Mentioning gate width and any tight spots when requesting a quote helps a hauler bring the right tools and people.
Hot tub electrical and water
A hot tub runs on its own electrical circuit, and that has to be safely disconnected before anyone cuts into the tub. An electrician can shut off and cap the circuit, and a crew should confirm the power is off before starting.
The water should be drained a day or two ahead through the tub's drain valve or with a submersible pump, directed to a lawn area where it will soak in rather than to a storm drain. A tub that has sat full for a long time may need its water treated or drained slowly, and its cover, steps and equipment go out with the shell.
Take It Down Yourself, Rent a Dumpster or Hire a Crew
A backyard structure can come out in three main ways:
Do it yourself
Possible for a small metal or plastic shed with basic tools and a truck. The owner still has to sort the materials, disconnect any power safely and haul everything to the right places.
Rent a dumpster
Useful when a family is taking down a large wood shed or deck over a weekend. A 10 or 15-yard container usually holds the debris, and heavy concrete counts against the weight allowance.
Hire a crew
A crew tears down, sorts and hauls in one job, at about $250 to $2,000 for a shed or $200 to $600 for a typical hot tub in 2026 guides. It suits large structures, hot tubs and tight access.
Shed & Hot Tub Removal FAQs
Does a concrete shed pad have to come out too?
No, but it often does when the space is going back to lawn or garden. A pad left in place can serve a new shed, a patio or a spot for a trailer. Breaking out and hauling concrete is heavy work, and HomeGuide's 2026 figures put shed removal with a concrete pad at $1,200 to $3,500, compared with $250 to $2,000 for the shed alone.
How is a hot tub removed from a backyard?
The tub is drained, its electrical circuit is disconnected, and the crew decides whether it can leave in one piece. Where a gate, a fence or a deck is in the way, the tub is cut into sections with a saw, and the shell, cabinet, frame and equipment are carried out separately. HomeGuide adds $100 to $130 when the tub sits up or down stairs, such as on a raised deck.
Can a metal shed be scrapped?
Usually. A steel or aluminum shed is mostly scrap metal once the floor, any wood framing and any roofing are separated, and scrap processors accept sheet metal and framing. The value of a single small shed is modest, but it can offset part of the removal cost. A metal shed also comes apart faster than a framed wood one, since it is held together with screws and bolts.
How long does shed removal take?
HomeGuide's 2026 figures put shed removal at anywhere from about four hours to two days. A small metal or plastic shed with nothing inside can be down and hauled away in part of a day. A large wood shed with a shingled roof, a wired interior, contents to sort and a concrete pad to break out can take a crew most of two days.
Free Shed & Hot Tub Removal Quote — Anderson
Free quote